3D Printer Kits Controller RAMPS 1.4 + Mega 2560 R3 + 5pcs A4988 Stepper Motor Driver with Heatsink + LCD 12864 Graphic Smart Display Controller with Adapter For Arduino RepRap


1.3D Printer Controller RAMPS 1.4 It is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino-compatible Mega with the powerful Arduino-compatible MEGA platform and has plenty room for expansion. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino-compatible MEGA shield for easy service, part replacement, upgrade-ability and expansion.
2.Mega 2560 R3 Fully compatible with original Arduino MEGA 2560 R3
3.A4988 Stepper Motor Driver A4988 is a complete micro stepping motor driver with built-in translator for easy operation (4)LCD 12864 Graphic Smart Display Controller
This full graphic Smart Controller contains a SD-Card reader, an rotary encoder and a 128 x 64 dot matrix LCD display. You can easy connect it to your Ramps board using the “smart adapter” included.

Specification:
Flat Cable Length: 32cm/12.6″
USB Cable Length: 45cm/17.7″;
Material: Plastic, Electronic Part
Main Color: As Picture Show

Package Content:
1x 3D Printer Controller RAMPS 1.4 Board
1x Arduino-Compatible Mega 2560 R3 board
5x A4988 Stepper Motor Driver with Heatsink
1x RAMPS LCD12864 Intelligent controller
1x Smart Adapter
2x FC flat cable
1x USB Cable

Product Features

  • 3D Printer Controller RAMPS 1.4
  • Fully compatible with original Arduino MEGA 2560
  • A4988 Stepper Motor Driver
  • LCD 12864 Graphic Smart Display Controller

Click Here If You Need More Detailed Info…

Published by

3DReality

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

3 thoughts on “3D Printer Kits Controller RAMPS 1.4 + Mega 2560 R3 + 5pcs A4988 Stepper Motor Driver with Heatsink + LCD 12864 Graphic Smart Display Controller with Adapter For Arduino RepRap”

  1. I would recommend this product for a inexpensive application (you get what you pay for) I would recommend this product for a inexpensive application. You get what you pay for.All of the electronics work fine EXCEPT the screen has developed a dark bar of pixels going though the center. I adjusted the potentiometer, and it got slightly better but the screen was to hard to see. Some of the pins on the Ramps 1.4 were slightly bent. Everything was functional, and has been for a few weeks now.The LCD is NOT a reprapdiscount product even though it is labeled…

Leave a Reply