Gowoops 3D Printer Kit RAMPS 1.4 + MEGA2560 + 5PCS A4988 Stepper Motor Driver + LCD 12864 Controller Board for Arduino RepRap

(1)3D Printer Controller RAMPS 1.4
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino-compatible Mega with the powerful Arduino-compatible MEGA platform and has plenty room for expansion. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino-compatible MEGA shield for easy service, part replacement, upgrade-ability and expansion.
(2)Mega 2560 R3
Fully compatible with original Arduino MEGA 2560 R3
(3)A4988 Stepper Motor Driver
A4988 is a complete micro stepping motor driver with built-in translator for easy operation (4)LCD 12864 Graphic Smart Display Controller
This full graphic Smart Controller contains a SD-Card reader, an rotary encoder and a 128 x 64 dot matrix LCD display. You can easy connect it to your Ramps board using the “smart adapter” included.

Specification:
Product Name: 3D Printer Reprap Kit
Flat Cable Length: 32cm/12.6″
USB Cable Length: 45cm/17.7″;
Material: Plastic, Electronic Part
Main Color: As Picture Show
Total Weight: 364g

Package Content:
1x 3D Printer Controller RAMPS 1.4 Board
1x Arduino-Compatible Mega 2560 R3 board
5x A4988 Stepper Motor Driver with Heatsink
1x RAMPS LCD12864 Intelligent controller
1x Smart Adapter
2x FC flat cable
1x USB Cable

Product Features

  • 3D Printer Controller RAMPS 1.4
  • Fully compatible with original Arduino MEGA 2560
  • A4988 Stepper Motor Driver
  • LCD 12864 Graphic Smart Display Controller

Detailed Information available on our Homepage…

Published by

3DReality

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

One thought on “Gowoops 3D Printer Kit RAMPS 1.4 + MEGA2560 + 5PCS A4988 Stepper Motor Driver + LCD 12864 Controller Board for Arduino RepRap”

  1. Bought a cheap HICTOP printer and the control board burned up less than a week into use. HICTOP never has responded to my emails, other than the automated email saying they’ll respond shortly. (See my review of that printer for further details.) After the work my son put into assembling the printer, and since the hardware is decent otherwise, I decided to spend another few bucks and make it a better printer. This kit is clearly a step above the monolithic board that HICTOP used. Very happy…

Leave a Reply