This is synchronous aluminum belt pulley for 3D printer.
This pulley is for 6mm width GT2 timing belt and 5mm shaft stepper motor.
There are two screws for each set of pulley (the screws are included in the package).
Belt Width: 6mm
Length: 10 meters (32.9 feet)
3D printer; motorized camera slider; belt sander; dishwasher; packing machinery; motorcycle; vehicle; mining equipment; dryer; conveyor and etc.
No folding, in order to avoid damage to the skeleton material, cause negative impact on the strength of the timing belt.
Avoid contact with chemicals (especially strong oxidizing acid, such as concentrated sulfuric acid, etc.).
Avoid contact with oil and water for a long-term.
When change the timing belt, the belt cannot take out unless the tension of the belt reduced to the lowest level and cannot use non-professional tools to pry it down.
5 x GT2 Timing Belt Pulley
1 x Allen Wrench
1 × 10 Meters GT2/2GT Timing Belt
- Timing belt pullet: Tooth: 16T; Bore: 5mm; Belt Width: 6mm.
- Timing belt: Length: 10 meters (32.9feet); Width: 6mm.
- GT2/2GT timing belt system is designed for linear motion and precision,high positioning accuracy.
- Adopt high quality aluminum and rubber, rust-proof, good toughness and long life.
- Package includes: 5 x GT2 Timing Belt Pulley; 1 x Allen Wrench; 1 × 10 Meters GT2/2GT Timing Belt.