This is the new SainSmart 3D Printer Starter Kit, developed specially for those beginners who are interested in 3D printer. You will have a complete set of Sainsmart’s most common and useful electronic components. You may learn about Sainsmart through using these basic projects.
Sainsmart RAMPS 1.4 is a Mega Pololu Shield, or RAMPS for short,designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform and has plenty room for expansion. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion. Additionally, a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack. This board is mostly based on Adrian’s Pololu_Electronics and work by Tonok. Copper etch resists methods suggested by Vik. Also inspired by Vik’s work with EasyDrivers. circuit design based mostly on Adrian’s Pololu_Electronics Joaz at RepRapSource.com supplied initial pin definitions and many design improvements. Much inspiration, suggestions, and ideas from Prusajr, Kliment, Maxbots, Rick, and many others in the RepRap community.
1 x RAMPS 1.4
1 x Mega 2560 R3
5 x A4988 driver
1 x LCD 12864 With Controller
1 x SD card breakout For ramps
1 x Cooler Fan for 3D ramps
6 x Mechanical Endstop with cable
1 x RAMPS 1.4 wiring cable
1 x Heatbed MK2B
5 x NEMA 17 Stepper Motors
1 x USB Cable
Note: Download the doumentation & codes here:
- Sainsmart Mega2560 R3 is an ATmega2560 as core microcontroller development board itself has 54 groups digital I / O input / output terminal (14 groups do PWM outputs), 16 sets of simulation than the input side, group 4 UARTs (hardware serial ports), using the 16 MHz crystal oscillator.
- Sainsmart A4988 driver is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection by Pololu. This stepper motor driver lets you control one bipolar stepper motor at up to 2 A output current per coil.
- Sainsmart LCD 12864 contains a SD-Card reader, an rotary encoder and a 128 Character x 64 Line LCD display.
- SainSmart Mechanical Endstop perfect for any 3D printer. 100% compatible with all Prusa and Mendel 3d printer variants.