WYZworks Regulated Power Supply 12v 30a 360w 3d Printer Reprap Mendel Prusa

This 12V Power Supply is more than capable of powering RepRap electronics, motors, extruder and a heating bed for in most 3D printer. Can also be used for any project that requires a lot of power.

This power supply does not include any wires. You will need to purchase a heavy gauge grounded AC plug with cord.

CAUTION: These power supplies can be switched between 110VAC and 220VAC. If you are in North America make sure to set the switch on the side of the power supply to 110VAC. In most other regions of the world 220VAC should be used.

Specifcations:

The input voltage & frequency range:85~264VAC/47~63Hz

Inrush starting current:20A@120VAC(Cold start)

Output adjusting range:±10% (rated output voltage)

Overload protection:(105% ~ 105% rated load), Self-recovery

Overvoltage protection:115%~135%(rated output voltage)

Short-circuit protection:Self-recovery

The startup time of output:≤2S@120VAC≤1.0S@230VAC

Hold-Up time of output:≥10mS@120VAC,≥20mS@230VAC

dielectric strength:Input-output: AC1500V, 1 min

Input -main case:AC1500V,1min

Output -main case:DC500V,1min

work environment:-10℃~50℃;20%~90%RH (not coagulate frost)

safety standard:design reference EN/UL60950

EMC standards:design reference EN55022 Class B;EN61000-4-2/-3/-4/-5/-6/-11

Size (length * width * height): 210*115*50mm

Product Features

  • Input: AC 110V/220V
  • Output: 12V DC 30A
  • Power: 360W

Detailed Information available on our Homepage…

Published by

3DReality

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

Leave a Reply